Adv kit is made to connect PDA and the logger together for all
Navigation softwares.
There are "plug and play" cables to connect almost any PDA to any
logger or GPS.
Connection box powers both unit through the cables. It powers the
logger also during the battey change thus preventing multiple
flights.
*
plug and play connection to almost any GPS and PDA
* low power consumption by use of efficient
switching mode regulator chip
* efficient RF noice damping
* for any software
Technical specification of the kit
- 12-40V power input
- power consumption at 12V typically 300mA (max 600mA)
(iPAQ + GPS)
- uses effective DC/DC switching mode regulator with efficient
RF noice damping for 5V output
(saves 50% compared to std regulator)
- guarded against reverse polarity.
- 1A internal fuse
- continuous power supply during battery change for GPS.
There are also special kits for two-seaters with 2A output and double PDA cables
Following equipment are supported at this moment
1. PDA´s
Compaq iPAQ 31/36/37xx
Compaq iPAQ 38/39xx
HP iPAQ 54/55xx
HP iPAQ 4150 and 2210
HP iPAQ 1710, RX3175, HX4700 and H6340
Dell Axim X3 and X5
ASUS
PALM
Toshiba
CASIO
HP Jornada
Fujitsu Pocket Loox
etc
2. Loggers :
Volkslogger old (5-pin round)
Volkslogger new RJ45 (square)
Colibri and LX20
Gambridge
Peschges VP8
3. GPS:
All Garmin 12V (4-pin round)
Peschges VP6 and 9
Filser LX5000 and 6000
Zander SR940
Haicom Hi203E
Note: Some units not included can be solved without major problems.
|